Current clamp TP-CC400

The Current clamp TP-CC400 is a current clamp that will allow your oscilloscope to measure electrical currents up to 400 Ampère AC/DC. When measuring with this current clamp, there is no need to break a closed circuit or to affect the isolation.

The wide jaws allow performing measurements on thick conductors.

For measuring DC current, a simple to operate zero adjust button is available.

To connect the Current clamp TP-CC400 to your oscilloscope, a BNC to banana measure lead is required, which must be ordered separately. For oscilloscopes with differential inputs, the Measure lead TP-C812B is recommended. For oscilloscopes with single-ended inputs the Measure lead TP-BNCI-100 is recommended.

Order code: TP-CC400
EAN: 7423620651606
Price: 120.90

Category: Current Clamps

The table below shows detailed specifications of the Current clamp TP-CC400.

Electrical
Bandwidth	DC to 20 kHz (-3dB)
Effective measurement range
40 A range	output 10 mV/A, 1 V = 100 A
400 A range	output 1 mV/A, 1 V = 1000 A
Accuracy
DC 40 A range	±(3.5% + 6 digits) (0 - 20 A) ±(4% + 10 digits) (20 A - 40 A)
DC 400 A range	±(3.5% + 6 digits) (0 - 300 A) ±(4.5% + 6 digits) (300 A - 400 A)
AC 40 A range	±(4% + 10 digits) (0 - 20 A) ±(5% + 10 digits) (20 A - 40 A)
AC 400 A range	±(4.5% + 10 digits) (0 - 300 A) ±(5% + 10 digits) (300 A - 400 A)
Output connection	cable with 2 shrouded 4 mm female banana sockets

Dimensions
Captured conductor size	20 mm maximum
Weight	240 g
Height	38 mm (1.5 inch)
Length	190 mm (7.5 inch)
Width	70 mm (2.8 inch)
Length of cable	30 cm (11.8 inch)

Power Requirements
Power indicator	Green LED
Battery type	Standard 9 V IEC 6F22 cell
Battery life	80 hours typical with alkaline
Low battery indication	Red LED

Ambient
Operating Temperature	0 to 50 °C
Relative Humidity	25 to 70%
Storage Temperature	-20 to 70 °C
Relative Humidity	25 to 80%

Certifications and Compliances
CE mark compliance	Yes
RoHS	Yes